How to Access IP Cam Through Router?
Have a wireless IP Wireless Camera (EasyN FS-613B). Trying to access it through a DLink DIR-615 router. Used the included setup software to identify the cam after following the setup procedure by...
View ArticleWow ... I just set one of these up earlier this week ! :)
I just set one of these (or rathter same make, different model) up earlier this week in the office. The setup software that came with it didn't find the cam until I did a hard reset and then the setup...
View ArticleReponse To Answer
First, yes, both computer and camera are on the same network (both plugged into same router). The setup software detects and identifies the IP address, etc, of the cam OK. It is here the problem...
View ArticleI know this may seem a silly question, but have you checked
all your network and subnet setting on the PC and the router, especially the subnet mask. I mention this because I once had to fix a similar type issue with someone else's PC and the problem was one of...
View ArticleSetting up CCTV online
- Wireless router must ne setup on a Public IP Address provided by Service provider.- Assign a static Ip address for your CAM on the LAN (192.168.0.X), Set the default gateway IP address for the...
View ArticleRouter
It is possible that you could have a rule/policy/ACL/route in the router that is preventing you from connecting to the cam. It could be a submask issue too as "Deadly Ernest" mentioned. The reason I...
View Article